Digitrip OPTIMizer
Hand Held Programmer

Digitrip OPTIMizer The OPTIMizer plugs into the front of the trip unit and is powered by a nine volt battery. The Digitrip OPTIMizer hand held programmer accesses, displays, and figures information from OPTIM Trip Units.

An operator can use the OPTIMizer to:

  • Complete Initial System Setup
    • Select breaker addresses.
    • Select system frequency (50/60 Hz).
    • Set system baud rate.
    • Set system password.
  • Configure the System
    • Change time-current setpoints.
    • Select protection options.
    • Select alarm levels.
  • Display Information
    • Breaker information.
    • Time-current setpoints.
    • Metered values.
    • Trip event information.
  • Test Trip Unit Performance
    • Phase and ground.
    • Trip/no trip.

Back to top of page.

Breaker Interface Module
Panel Mounted User Interface

Breaker Interface Module The Breaker Interface Module can be mounted directly on the assembly or at a remote location and can be used to access, configure, and display information from OPTIM Trip Units.

An operator can use the Breaker Interface Nodule to:

  • Setup Initial System
    • Select system frequency (50/60 Hz).
    • Set system password.
  • Configure the System
    • Change time-current setpoints.
    • Select protection options.
    • Select alarm levels.
  • Display Information
    • Breaker information.
    • Time-current setpoints.
    • Metered values.
    • Trip event information.
  • Test Trip Unit Performance
    • Phase and ground.
    • Trip/no trip.
All Features of the OPTlMizer PLUS...
  • Expanded Energy Monitoring
    • Set addresses for group energy monitoring.
    • Group energy readings.
  • Local and Remote Indication
    • Remote indication/alarming.
    • Breaker status LED indication.
  • Expanded Communications
    • Communicates with:
    • OPTIM Trip Units.
    • Digitrip RMS 810 and 910 Trip Units.
    • IQ Energy Sentinels and
    • Universal IQ Energy Sentinels.
    • Up to 50 devices.

Back to top of page.

IMPACC Communications
Programming and Other Capabilities from a Personal Computer

Waveform and Harmonic Display All OPTIM programming, configuration advance warning, diagnostic, monitoring, and control capabilities can be accessed from a central personal computer using IMPACC Series III software. Other software packages are available, including a Coordination Package that displays, configures, and coordinates time-current protection curves for OPTIM Trip Units and other devices that can be included on an IMPACC System.

Custom Billing Software, a stand alone application specific software package, provides the capabilities to determine energy usage data by individual departments or tenants in a facility...and then creates "electric bills" based on this data.

Trip Curve Display Waveform and harmonic display software is capable of performing a waveform capture of phase currents A, B. and C. In addition, total harmonic distortion (THD) and individual harmonic contents of phase currents A, B. and C neutral or ground can be displayed.



Back